Siemens SINUMERIK 840D sl Programming Manual page 141

List of the result parameters
The measuring variant "1 circular spigot" provides the following result parameters:
Table 2- 23
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [16]
_OVR [17]
_OVR [18]
_OVI [0]
_OVI [2]
_OVI [3]
_OVS_TNAME
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 255).
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
"1 circular spigot" result parameters
Description
Circular spigot diameter setpoint
Circular spigot center point setpoint in the 1st axis of the plane
Circular spigot center point setpoint in the 2nd axis of the plane
Circular spigot diameter actual value
Circular spigot center point actual value in the 1st axis of the
plane
Circular spigot center point actual value in the 2nd axis of the
plane
Circular spigot diameter difference
Circular spigot center point difference in the 1st axis of the plane
Circular spigot center point difference in the 2nd axis of the plane
D number or WO number
Measuring cycle number
Measuring version
Tool name
Measuring variants
2.3 Measure workpiece (milling)
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
141