2.1.2
Selection of the measuring variants via softkeys (turning)
The following shows the measuring variants of the turning technology as a menu tree.
Preconditions
All of the measuring variants available in the control are shown in the display. However, on a
specific system, only those steps can be selected that are possible for the set extended
technology.
1)
2)
3)
4)
Turning technology menu tree
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
The "Inside diameter" softkey is displayed if bit1 =1 is set in the general SD 54764
$SNS_MEA_FUNCTION_MASK_TURN.
The "3D" softkey is displayed if bit 1 = 1 is set in the general SD 54760
$SNS_MEA_FUNCTION_MASK_PIECE.
The "kinematics" softkey is only displayed in the G code program, if the "Measure
kinematics" option is set.
These softkeys are displayed if the "Milling" extended technology is set (channel-specific
MD 52201 $MCS_TECHNOLOGY_EXTENSION = 2).
→
4)
→
Length (CYCLE973)
(Page 57)
Radius in ring (CYCLE976)
4)
(Page 86)
Radius on surface (CYCLE973)
(Page 60)
Calibrate on ball (CYCLE976)
4)
(Page 93)
Calibrate in groove (CYCLE973)
(Page 63)
→
Front edge (CYCLE974)
(Page 67)
Inside diameter (CYCLE974,
1)
CYCLE994) (Page 71)
Outer diameter (CYCLE974,
CYCLE994) (Page 76)
→
Set edge (CYCLE978)
(Page 96)
Align edge (CYCLE998)
(Page 100)
Groove (CYCLE977)
(Page 106)
Rib (CYCLE977)
(Page 110)
Measuring variants
2.1 General requirements
51