2.2.6
Turning measurement - inside diameter (CYCLE974, CYCLE994)
Function
With this measuring version, the inside diameter of cylindrical workpieces can be measured.
Diameter and radius programming are supported.
The measurement result (measurement difference) can be used as follows:
● Correction in the work offset (only for 1-point measurements)
● Offset of a tool
● Measurement without offset
Note
Extended measurement
Information on measurement in conjunction with a third axis can be found in Chapter
Extended measurement (Page 81).
Measuring principle
The measuring cycle determines the actual value of an inner diameter using a 1-point
measurement or 2-point measurement symmetrically around the workpiece zero (center of
rotation). The 2-point measurement is performed by reversing the spindle through 180
degree of the workpiece or by making measurements above and below the center of
rotation.
An extended tool offset in the summed and setup offsets is possible.
For the tool offset, generally empirical values can be included in the calculation.
Figure 2-5
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Measure: Inside diameter (CYCLE974)
Measuring variants
2.2 Measure workpiece (turning)
71