Siemens SINUMERIK 840D sl Programming Manual page 145

Parameters Description
TUL Upper tolerance limit, workpiece (only for dimensional tolerance "Yes")
TLL Lower tolerance limit, workpiece (only for dimensional tolerance "Yes")
Other parameters and correction targets can be set in the general SD 54760$SNS_MEA_FUNCTION_MASK_PIECE.
1)
List of the result parameters
The measuring variant "Outer circle segment" provides the following result parameters:
Table 2- 24
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [16]
_OVR [17]
_OVR [18]
_OVI [0]
_OVI [2]
_OVI [3]
_OVS_TNAME
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 255).
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Machine manufacturer
Please observe the machine manufacturer's instructions.
"Outer circle segment" result parameters
Description
Circle segment diameter setpoint
Center point setpoint in the 1st axis of the plane
Center point setpoint in the 2nd axis of the plane
Circle segment diameter actual value
Center point actual value in the 1st axis of the plane
Center point actual value in the 2nd axis of the plane
Circle segment diameter difference
Center point difference in the 1st axis of the plane
Center point difference in the 2nd axis of the plane
D number or WO number
Measuring cycle number
Measuring version
Tool name
Measuring variants
2.3 Measure workpiece (milling)
Unit
mm
mm
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
145