Selection Of The Measuring Variants Via Softkeys (Milling) - Siemens SINUMERIK 840D sl Programming Manual

2.1.3

Selection of the measuring variants via softkeys (milling)

The following shows the measuring variants for the milling technology as a menu tree.
Preconditions
All of the measuring variants available in the control are shown in the display. However, on a
specific system, only those steps can be selected that are possible for the set extended
technology.
1)
2)
3)
4)
Milling technology menu tree
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
The "Inside diameter" softkey is displayed if bit1 =1 is set in the general SD 54764
$SNS_MEA_FUNCTION_MASK_TURN.
The "3D" softkey is displayed if bit 1 = 1 is set in the general SD 54760
$SNS_MEA_FUNCTION_MASK_PIECE.
The "kinematics" softkey is only displayed in the G code program, if the "Measure
kinematics" option is set.
These softkeys are only displayed in the G code program if the"turning" extended
technology is set (channel-specific MD 52201 $MCS_TECHNOLOGY_EXTENSION = 1).
→ → Length (CYCLE976)
(Page 83)
Radius in ring (CYCLE976)
(Page 86)
Radius at edge (CYCLE976)
(Page 90)
Calibrate on ball (CYCLE976)
(Page 93)
Calibrate in groove (CYCLE973)
4)
(Page 63)
→ Set edge (CYCLE978)
(Page 96)
Align edge (CYCLE998)
(Page 100)
Groove (CYCLE977)
(Page 106)
Rib (CYCLE977)
(Page 110)
→ Right-angled corner (CYCLE961)
(Page 114)
Any corner (CYCLE961)
(Page 118)
Measuring variants
2.1 General requirements
53