Siemens SINUMERIK 840D sl Programming Manual page 207

Parameters Description
V Lateral offset (only for measuring axis "Z", for G17)
The offset is active when calibrating the 3rd measuring axis, if the calibration tool diameter
is larger than the upper diameter of the probe. Here, the tool is offset from the center of
the probe by the tool radius, minus the value of V. An offset axis must be specified.
DFA Measurement path
TSA Safe area for the measurement result
List of the result parameters
The measuring variant "Calibrate probe" provides the following result parameters:
Table 2- 39
Parameters
_OVR [8]
_OVR [10]
_OVR [12]
_OVR [14]
_OVR [16]
_OVR [18]
_OVR [9]
_OVR [11]
_OVR [13]
_OVR [15]
_OVR [17]
_OVR [19]
_OVR [27]
_OVR [28]
_OVI [2]
_OVI [3]
_OVI [5]
_OVI [9]
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
"Calibrate probe" result parameters
Description
Trigger point in minus direction, actual value of 1st geometry axis
Trigger point in plus direction, actual value of 1st geometry axis
Trigger point in minus direction, actual value of 2nd geometry axis
Trigger point in plus direction, actual value of 2nd geometry axis
Trigger point in minus direction, actual value of 3rd geometry axis
Trigger point in plus direction, actual value of 3rd geometry axis
Trigger point in minus direction, difference of 1st geometry axis
Trigger point in plus direction, difference of 1st geometry axis
Trigger point in minus direction, difference of 2nd geometry axis
Trigger point in plus direction, difference of 2nd geometry axis
Trigger point in minus direction, difference of 3rd geometry axis
Trigger point in plus direction, difference of 3rd geometry axis
Work offset range
Safe area
Measuring cycle number
Measuring version
Probe number
Alarm number
Measuring variants
2.5 Measure tool (milling)
Unit
mm
mm
mm
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
207