Siemens SINUMERIK 840D sl Programming Manual page 227

No. Screen form Cycle
parameters parameters
S_KNUM1
3 Selection
S_PRNUM
4 Icon+
number
5 X0 S_SETV
6 DFA S_FA
7 TSA S_TSA
S_MA
8 X
9 S_MD
10 Measureme S_NMSP
nts
S_TNAME
11 TR
12 DL S_DLNUM
13 TZL S_TZL
14 DIF S_TDIF
S_TUL
15 TUL
16 TLL S_TLL
17 TMV S_TMV
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Meaning
Correction in tool offset
2)
Values: UNITS:
TENS:
HUNDREDS:
0 = No correction
1 to max. 999 D numbers (cutting edge numbers) for tool offset,
for additive and setup offset, see also
THOUSANDS: Reserved
TEN THOUSANDS: Tool offset
0 = No specification (offset in tool geometry normal, not inverted)
1 = Offset inverted
HUNDRED THOUSANDS: Tool offset
0 = No specification (offset in tool geometry)
1 = Offset of length L1
2 = Offset of length L2
3 = Offset of length L3
MILLIONS: Tool offset
0 = No specification (offset of the tool radius wear)
1 = Tool offset, additive offset (AO)
Tool offset value is added to the existing AO
2 = Tool offset, setup offset (SO)
SO (new) = SO (old) + AO (old) offset value, AO (new) = 0
3 = Tool offset, setup offset (SO)
Tool offset value is added to the existing SO
4 = Tool offset, geometry
Number of the field of the probe parameter (not probe number)
(value range 1 to 12)
Setpoint
Measurement path
Safe area
Number of the measuring axis
Values: 1 = 1st axis of the plane (for G17 X)
2 = 2nd axis of the plane (for G17 Y)
3 = 3rd axis of the plane (for G17 Z) Measurement in tool direction
Measuring direction of the measuring axis
Values: 1 = Positive measuring direction
2 = Negative measuring direction
Number of measurements at the same location
Tool name
3)
Setup additive offset DL number
Work offset
2), 3)
Dimensional difference check
Upper tolerance limit
3)
Lower tolerance limit
3)
Offset range for averaging
3.1 Overview of measuring cycle parameters
S_DLNUM
2)
2)
2)
5)
5)
5)
(value range 1 to 3)
7)
(value range 1 to 9)
2)
5)
2), 3)
2)
Parameter lists
227