Siemens SINUMERIK 840D sl Programming Manual page 254

Parameter lists
3.2 Additional parameters
Additional correction options when measuring workpiece:
1. Work offsets
2. Tool offsets
Table 3- 15 Supplementary parameter when measuring tool
Screen form Transfer
parameters parameters
Calibration data S_PRNUM
set
S_VMS
F
S_MVAR
Selection,
measuring steps
Selection S_MVAR
Selection S_MVAR
Number S_NMSP
S_EVNUM
Data set, empirical
values
254
– Offset in the basic reference
– Offset in the channel-specific basic WO
– Offset in the global basic WO
– Offset, coarse or fine
– Tool offset in geometry or wear
– Tool offset, inverted or not inverted
– Tool offset in radius or length L1 or L2 or L3
Description
Number of the data set with the calibrated values of the probe
Measuring feedrate when calibrating the probe
Input of max. 3 feedrates and 3 spindle speeds when measuring with
rotating spindle
Tool offset in geometry or wear
Measurement in the machine coordinate system or workpiece coordinate
system
Number of measurements at the same location
Generating empirical values for correction in a tool
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
-
mm/min
-
-
-
-
-
Measuring cycles