Measuring variants
2.2 Measure workpiece (turning)
List of the result parameters
The measuring variant "Outside diameter" provides the following result parameters:
Table 2- 8
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [3]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [7]
_OVR [16]
_OVR [17]
_OVR [18]
_OVR [19]
_OVI [0]
_OVI [2]
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 255).
80
"Outside diameter" result parameters
Description
Diameter setpoint (note measuring axis
Diameter setpoint in 1st axis of the plane → only for
Diameter setpoint in 2nd axis of the plane → only for
Diameter setpoint in 3rd axis of the plane → only for
Diameter actual value
Diameter actual value in 1st axis of the plane → only for
Diameter actual value in 2nd axis of the plane → only for
Diameter actual value in 3rd axis of the plane → only for
Diameter difference
Diameter difference in 1st axis of the plane → only for
Diameter difference in 2nd axis of the plane → only for
Diameter difference in 3rd axis of the plane → only for
D number
Measuring cycle number
)
S_MA
S_MA=1
S_MA=2
S_MA=3
S_MA=1
S_MA=2
S_MA=3
S_MA=1
S_MA=2
S_MA=3
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
Measuring cycles