Siemens SINUMERIK 840D sl Programming Manual page 75

List of the result parameters
The measuring variant "Inside diameter" provides the following result parameters:
Table 2- 7
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [3]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [7]
_OVR [16]
_OVR [17]
_OVR [18]
_OVR [19]
_OVI [0]
_OVI [2]
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 255).
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
"Inside diameter" result parameters
Description
Diameter setpoint (note measuring axis
Diameter setpoint in 1st axis of the plane → only for
Diameter setpoint in 2nd axis of the plane → only for
Diameter setpoint in 3rd axis of the plane → only for
Diameter actual value
Diameter actual value in 1st axis of the plane → only for
Diameter actual value in 2nd axis of the plane → only for
Diameter actual value in 3rd axis of the plane → only for
Diameter difference
Diameter difference in 1st axis of the plane → only for
Diameter difference in 2nd axis of the plane → only for
Diameter difference in 3rd axis of the plane → only for
D number
Measuring cycle number
Measuring variants
2.2 Measure workpiece (turning)
)
S_MA
S_MA=1
S_MA=2
S_MA=3
S_MA=1
S_MA=2
S_MA=3
S_MA=1
S_MA=2
S_MA=3
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
75