Siemens SINUMERIK 840D sl Programming Manual page 243

No. Screen form Cycle
parameters parameters
S_NMSP
19 Measurement
s
S_MCBIT
20
21 _DMODE
22 _AMODE
All default values = 0 or marked as the range of values a to b
1)
Display depends on the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE
2)
Intermediate positioning, circling around the ball at the equator
3)
3 sphere measurement: The same diameter setpoint applies for all three spheres (_SETV)
4)
Default value for
5)
S_TNVL=1.2
Correction in WO: Correction is only performed in the WO when the determined distortion is below the
value.
If WO "fine" has not been set up in MDs, correction is according to WO "coarse"
6)
For measuring variant "Measure three spheres", correction in a global basic frame is not possible (
7)
3016), as the frame does not have a rotation component.
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Meaning
Number of measurements at the same location
Reserved
Display mode
Values: UNITS: Machining plane G17/G18/G19
0 = compatibility, the plane active before the cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Alternative mode
3.1 Overview of measuring cycle parameters
(value range 1 to 9)
2)
Parameter lists
limit
S_TNVL
= 3001 to
S_KNUM
243