Viewing The Power Controller Status - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
This table or list provides the following information:
Parameter
slot
detected-module
temperature
current-supply
voltage-supply
Section 3.2.7

Viewing the Power Controller Status

To view information about the power controller, type:
show chassis power-controller pm-status
A table or list similar to the following example appears:
ruggedcom# show chassis power-controller pm-status | tab
PM MOV
SLOT PROTECTION
-------------------------------------------------
pm1 na
This table or list provides the following information:
Parameter
pm-slot
mov-protection
pm-temperature
pm-current
pm-voltage
Viewing the Power Controller Status
Description
Synopsis: { ---, pm1, pm2, main, sm, lm1, lm2, lm3, lm4, lm5, lm6, swport, eth, serport,
celport, cm, em, trnk }
The slot name, as marked on the silkscreen across the top of the chassis.
Synopsis: A string 1 to 60 characters long
The installed module's type specifier.
Synopsis: An integer between 55 and 125
The temperature, in degrees C, of the installed module. If multiple temperature sensors are
present on the board, the maximum reading is reported.
Synopsis: An integer between 0 and 15000
The power supply current, in mA, being drawn by the installed module.
Synopsis: An integer between 0 and 15000
Prerequisite: /ruggedcom:ruggedcom-internal/ruggedcom:chassis-type/
ruggedcom:family != 'RX1400'
The power supply voltage, in mV, seen by the installed module.
PM PM
TEMPERATURE CURRENT
48 2666
Description
Synopsis: { pm1, pm2 }
The name of the power module slot as labeled on the chassis.
Synopsis: { na, working, damaged }
The state of the MOV protection circuit.
Synopsis: An integer between 55 and 125
The temperature (Celsius) inside the power module.
Synopsis: An integer between 0 and 15000
The current (mA) sourced by the power module.
Synopsis: An integer between 0 and 15000
The voltage (mV) sourced by the power module.
PM
VOLTAGE
3387
Chapter 3
Device Management
55