RUGGEDCOM ROX II
CLI User Guide
Section 5.20.10.3
Deleting a Redistribution Metric
To delete a redistribution metric for dynamic RIP routes, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the metric by typing:
no routing rip redistribute [ bgp | ospf | connected | static | kernel ]
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.20.11
Managing Routing Interfaces
The following sections describe how to configure and manage routing interfaces for dynamic RIP routes:
•
Section 5.20.11.1, "Viewing a List of Routing Interfaces"
•
Section 5.20.11.2, "Configuring a Routing Interface"
Section 5.20.11.1
Viewing a List of Routing Interfaces
To view a list of routing interfaces for a RIP network, type:
show running-config routing rip interface
A table or list similar to the following example appears:
ruggedcom# show running-config routing rip interface | tab
IFNAME
MODE
----------------------------------------------------------------------
dummy0
-
fe-cm-1
-
switch.0001
-
Section 5.20.11.2
Configuring a Routing Interface
To configure a routing interface for a RIP network, do the following:
NOTE
OSPF regards router interfaces as either passive or active, sending OSPF messages on active
interfaces and ignoring passive interfaces.
1.
Make sure the CLI is in Configuration mode.
Navigate to routing » rip » interface » {name}, where {name} is the name of the interface.
2.
3.
Configure the authentication settings by typing the following commands:
Deleting a Redistribution Metric
KEY
CHAIN
STRING
PASSIVE
-
-
-
-
-
-
-
-
-
RECEIVE
SEND
SPLIT
VERSION
VERSION
HORIZON
-
-
yes
-
-
yes
-
-
yes
Chapter 5
Setup and Configuration
355