Configuring Esp Encryption; Viewing A List Of Esp Algorithms; Adding Esp Algorithms - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.29.8.1

Configuring ESP Encryption

To configure the encryption algorithm for the Encapsulate Security Payload (ESP), do the following:
1. Make sure the CLI is in Configuration mode.
Navigate to tunnel » ipsec » connection » {connection} » esp, where {connection} is the name of the
2.
connection.
3. Configure the encryption algorithm by typing:
tunnel ipsec connection connection esp modgroup modgroup
Where:
• connection is the name of the connection
• modgroup is the value of the modgroup
4. If required, add additional cipher algorithms. For more information on how to add algorithms, refer to
Section 5.29.8.3, "Adding ESP Algorithms"
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.29.8.2

Viewing a List of ESP Algorithms

To view a list of algorithms for the Encapsulate Security Payload (ESP) protocol, type:
show running-config tunnel ipsec connection connection esp algorithm
Where:
• connection is the name of the connection
If algorithms have been configured, a table or list similar to the following example appears:
tunnel
ipsec
connection ipsec-12
esp algorithm aes256 sha1
!
!
!
!
If no algorithms have been configured, add algorithms as needed. For more information, refer to
"Adding ESP Algorithms".
Section 5.29.8.3

Adding ESP Algorithms

To add a new algorithm for the Encapsulated Security Payload (ESP) protocol, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the algorithm by typing:
tunnel ipsec connection connection esp algorithm cipher cipher hash method
Configuring ESP Encryption
Chapter 5
Setup and Configuration
Section 5.29.8.3,
469