Table of Contents
Advertisement
Chapter 3
Device Management
A confirmation message appears. Type yes to load the file or no to abort.
3.
Section 3.11
Upgrading/Downgrading the RUGGEDCOM ROX II
Software
The following sections describe how to upgrade and downgrade the RUGGEDCOM ROX II software:
•
Section 3.11.1, "Configuring the Upgrade Source"
•
Section 3.11.2, "Setting Up an Upgrade Server"
•
Section 3.11.3, "Upgrading the RUGGEDCOM ROX II Software"
•
Section 3.11.4, "Stopping/Declining a Software Upgrade"
•
Section 3.11.5, "Downgrading the RUGGEDCOM ROX II Software"
Section 3.11.1
Configuring the Upgrade Source
Firmware for upgrading or downgrading RUGGEDCOM ROX II can be uploaded from either an upgrade server or
a portable USB Mass Storage drive. For information about setting up an upgrade server, refer to
"Setting Up an Upgrade
IMPORTANT!
A Trusted Root CA (Certified Authority) certificate is required if using HTTPS to upload packages from
an upgrade server. The certificate is chosen using the Server CA parameter. If a certificate is not
available, it must be uploaded to the device. For more information, refer to
CA Certificate and
To specify the source of the RUGGEDCOM ROX II software and a specific version, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Configure the following parameter(s) as required:
Parameter
repository-url { repository-url }
target-version { target-version }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
72
Server".
CRL".
Description
Synopsis: A string
The URL for the upgrade server or file system. Supported URIs
are HTTP, HTTPS and FTP. To upgrade from a USB flash drive
or microSD/microSDHC drive (if applicable), the URL format is
"usb://<usb-device-name>/path-to-repository" or "sd://sd-1//path-
to-repository". Run "show chassis" to determine the name of the
USB device. Note that only one single partition is supported for
either data medium.
Synopsis: A string
The target software version. Specify a specific software release
in the form of 'rrX.Y.Z' or enter 'current' to upgrade to the latest
software release available on the upgrade server.
Upgrading/Downgrading the RUGGEDCOM ROX II
RUGGEDCOM ROX II
CLI User Guide
Section 3.11.2,
Section 4.7.1.3, "Adding a
Software
Advertisement
Table of Contents
Troubleshooting
