Table of Contents
Advertisement
Chapter 3
Device Management
Download complete.
Preparing partition #2 to be flashed...
Flashing image to partition#2...
progress: 100%
Flashed image detected to be version ROX 2 (2011-03-29 03:04)
The other partition was imaged successfully.
A reboot is required to boot the other partition.
4.
If the software downgrade is successful, reboot the device. For more information, refer to
"Rebooting the
Section 3.12
Managing RUGGEDCOM ROX II Applications
RUGGEDCOM ROX II applications are special add-ons that extend the functionality of ROX, such as enhanced
support for other ROX products (e.g. RUGGEDCOM CROSSBOW, RUGGEDCOM ELAN, etc.). They are
installed and upgraded the same as the RUGGEDCOM ROX II operating system, in that they are first installed
on the inactive partition and are only activated after a reboot. This makes it possible to decline or undo the
installation if the application creates undesirable results. The currently active partition is also unaffected when an
application is being installed or upgraded.
All RUGGEDCOM ROX II applications are released as repositories and must be hosted by an upgrade server.
For more information about setting up an upgrade server, refer to
The following sections describe how to manage ROX applications on the device:
•
Section 3.12.1, "Viewing a List of Installed Applications"
•
Section 3.12.2, "Installing an Application"
•
Section 3.12.3, "Upgrading an Application"
•
Section 3.12.4, "Uninstalling an Application"
•
Section 3.12.5, "Managing Application Repositories"
Section 3.12.1
Viewing a List of Installed Applications
To view a list of RUGGEDCOM ROX II applications installed on the device, type:
show admin software-upgrade apps installed-apps
If applications have been installed, a table or list similar to the following example appears:
ruggedcom# show admin software-upgrade apps installed-apps
APP NAME
VERSION
-------------------
crossbow
4.1.2
elan
8.0.2
If no applications have been installed, install applications as needed. For more information, refer to
Section 3.12.2, "Installing an
78
Device".
Application".
Section 3.11.2, "Setting Up an Upgrade
Managing RUGGEDCOM ROX II Applications
RUGGEDCOM ROX II
CLI User Guide
Section 3.5,
Server".
Advertisement
Table of Contents
Troubleshooting
