Configuring A Cellular Modem Interface - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
network status
phone number
This list provides the following information:
Parameter
network-supported
esn
ecio
rssi-indicator
network-operator
network-in-use
network-status
phone-number
Section 3.22.6

Configuring a Cellular Modem Interface

To configure a cellular modem interface, do the following:
NOTE
Cellular modems with support for EDVO network technology are backwards compatible with CDMA 2G
and CDMA 1x RTT networks.
Cellular modems with support for HSPA+ network technology are backwards compatible with GSM,
GPRS, EDGE, UMTS, HSDPA/HSUPA networks.
1. Make sure the CLI is in Configuration mode.
2. Navigate to interface » wan » {interface}, where {interface} is the cellular modem interface.
3. Configure the following parameter(s) as required:
Parameter
enabled
link-alarms
Configuring a Cellular Modem Interface
Registered
9546496654
Description
Synopsis: A string 1 to 128 characters long
Wireless technologies supported by the modem
Synopsis: A string 1 to 128 characters long
The Electronic Serial Number of the modem. ESN is only avaible for
the CDMA modem.
The total energy per chip per power density value in dBm
The Received Signal Strength Indicator in dBm
Synopsis: A string 1 to 128 characters long
The wireless network operator currently in use
Synopsis: A string 1 to 128 characters long
The network technology currently in use by the modem
Synopsis: A string 1 to 128 characters long
The registration status of the modem with the wireless network
Synopsis: A string 1 to 128 characters long
The subscriber phone number of the CDMA modem
Description
Synopsis: true or false
Default: false
Provides the option to enable or disable this interface. When
unchecked(i.e disabled), the interface will prevent all frames from
being sent and received on that interface.
Synopsis: true or false
Default: true
Chapter 3
Device Management
129