Table of Contents
Advertisement
Chapter 5
Setup and Configuration
IMPORTANT!
The router can only share routing information with neighbors that use the same authentication method
and password.
NOTE
Authentication adds a small overhead due to the encryption of messages. It is not recommended for
completely private networks with controlled access.
The following sections describe how to configure and manage message digest keys:
•
Section 5.21.10.1, "Viewing a List of Message Digest Keys"
•
Section 5.21.10.2, "Adding a Message Digest Key"
•
Section 5.21.10.3, "Deleting a Message Digest Key"
Section 5.21.10.1
Viewing a List of Message Digest Keys
To view a list of message digest keys for an OSPF routing interface, type:
• For Standard OSPF Routes
show running-config routing ospf interface name message-digest-key
• For VRF Routes via OSPF
show running-config routing ospf interface name message-digest-key
Where:
• vrf is the name of the chosen VRF
• name is the name of the routing interface
If keys have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf interface switch.0001 message-digest-key
routing ospf
interface switch.0001
message-digest-key 1
md5 RUGGEDCOM
!
!
!
If no message digest keys have been configured, add keys as needed. For more information, refer to
Section 5.21.10.2, "Adding a Message Digest
Section 5.21.10.2
Adding a Message Digest Key
To add a message digest key to an OSPF routing interface, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the key by typing:
378
Key".
RUGGEDCOM ROX II
CLI User Guide
Viewing a List of Message Digest Keys
Advertisement
Table of Contents
Troubleshooting
