Chapter 5
Setup and Configuration
Section 5.27.7.2
Adding a VRRP Monitor
To add a VRRP monitor, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the instance by typing:
services vrrp instance name monitor interface
Where:
• name is the name of the VRRP instance
• interface is the name of the extra interface to monitor
3.
Configure the following parameter(s) as required:
Parameter
weight { weight }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.27.7.3
Deleting a VRRP Monitor
To delete a VRRP monitor, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the monitor by typing:
no services vrrp instance name monitor interface
Where:
• name is the name of the VRRP instance
• interface is the name of the extra interface to monitor
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.27.8
Managing Track Scripts
Track scripts are used to associate VRRP trackers with VRRP instances.
The following sections describe how to configure and manage track scripts:
•
Section 5.27.8.1, "Viewing a List of Track Scripts"
•
Section 5.27.8.2, "Adding a Track Script"
•
Section 5.27.8.3, "Deleting a Track Script"
444
Description
Synopsis: An integer between 254 and 254
The amount by which to increase or decrease the router's priority.
When negative, the priority decreases by this amount when
the interface falls. When positive, the priority increases by this
amount when the interface is up. When not set, the state changes
to the fault state when the interface falls.
RUGGEDCOM ROX II
CLI User Guide
Adding a VRRP Monitor