Adding A Redistribution Metric; Deleting A Redistribution Metric - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Where:
• vrf is the name of the chosen VRF
If metrics have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf redistribute
routing ospf
redistribute bgp
no metric-type
no metric
!
!
If no redistribution metrics have been configured, add metrics as needed. For more information, refer to
Section 5.21.8.2, "Adding a Redistribution
Section 5.21.8.2

Adding a Redistribution Metric

To add a redistribution metric for dynamic OSPF routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the metric by typing:
• For Standard OSPF Routes
routing ospf redistribute [ bgp | rip | connected | static | kernel ]
• For VRF Routes via OSPF
routing ospf vrf vrf redistribute [ bgp | rip | connected | static | kernel ]
Where:
• vrf is the name of the chosen VRF
3. Configure the following parameter(s) as required:
Parameter
metric-type { metric-type }
metric { metric }
route-map { route-map }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.21.8.3

Deleting a Redistribution Metric

To delete a redistribution metric for dynamic OSPF routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the metric by typing:
374
Metric".
Description
Synopsis: An integer between 1 and 2
Default: 2
The OSPF exterior metric type for redistributed routes.
Synopsis: An integer between 0 and 16777214
The metric for redistributed routes.
The route map name.
RUGGEDCOM ROX II
CLI User Guide
Adding a Redistribution Metric