User Permissions - Siemens RUGGEDCOM ROX II User Manual

Chapter 1
Introduction
Section 1.5

User Permissions

The following table lists the operation, configuration, and action commands permitted to the administrator,
operator, and guest users.
Types of user access:
• Create (C) - can create and remove optional parameters
• Execute (E) - can run an action or command
• No - no read/write/execute access
• Read (R) - read access
• Update (U) - can modify existing parameter
Commands/Paths Permitted
config private | exclusive | no-confirm
/admin/software-upgrade
/admin/rox-imaging
/admin/authentication
/admin/authentication/password-
complexity
/admin/logging
/admin/alarms (status)
/admin/alarms-config/
/admin/users
/admin/users/userid
/admin/cli
/admin/snmp
/admin/netconf
/admin/dns
/admin/webui
/admin/scheduler
/admin/contact
/admin/hostname
/admin/location
/admin/session-limits
/admin/session-security
10
Access
Administrator Operator
Allowed Allowed
R/U No
R/U No
R/U No
R/U R
C/R/U No
R R
R/U R/U
C/R/U No
R/U R/U
R/U R/U
C/R/U No
R/U No
C/R/U No
R/U R/U
C/R/U No
R/U R/U
R/U R/U
R/U R/U
R/U R/U
R/U R/U
Notes
Guest
No
No
No
No
No
No
No Administrator and operator can see status
of active-alarms, acknowledge and clear
alarms
No Administrator and operator cannot create
or delete alarm-lists
No
No Operator can only change own password
and cannot create users.
No
No
No
No
No
No
No
No
No
No
No
RUGGEDCOM ROX II
CLI User Guide
User Permissions