Viewing A List Of Static Labels; Adding A Static Label - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
ip-address
in-label
out-label
nexthop
If no static label binding has been configured, configure binding as needed. For more information about
configuring static-binding, refer to
Section 5.41.5.2

Viewing a List of Static Labels

To view a list of static labels, type:
show running-config mpls static-mpls binding [ ipv4 | ipv6 ]
If static labels have been configured, a list similar to the following example appears:
ruggedcom# show running-config mpls static-mpls binding ipv4
mpls
static-mpls
binding
ipv4
dest-address 192.168.52.52/32
next-hop 192.168.10.2
out-label 16
!
!
!
!
!
If no static labels have been configured, add labels as needed. For more information about adding static labels,
refer to Section 5.41.5.3, "Adding a Static
Section 5.41.5.3

Adding a Static Label

To add a static label, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add a static label by typing:
mpls static-mpls binding [ ipv4 | ipv6 ] dest-address address
Where:
• address is the destination address and prefix.
3. Configure the following parameter(s) as required:
Viewing a List of Static Labels
Description
Synopsis: A string
The destination address prefix.
Synopsis: A string
The incoming (local) label.
Synopsis: A string
The outgoing (remote) label.
Synopsis: A string
The destination next hop router.
Section 5.41.5.3, "Adding a Static
Label".
Setup and Configuration
Label".
Chapter 5
603