Feature Keys - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
NOTE
A reboot is required if a module is installed in a slot that was empty when the device was started.
Section 1.2

Feature Keys

Feature keys add features to an existing installation of RUGGEDCOM ROX II. They can be purchased and
installed at any time.
Three feature keys are currently available: L2STD, L3STD and L3SEC. By default, each new RX1500/RX1501/
RX1510/RX1511/RX1512 is ordered with a base feature key, which is permanently installed on the device.
Additional feature keys can be installed on the compact flash card or placed on a USB Mass Storage device,
which allows them to be moved to other devices when needed.
NOTE
Each feature key is signed with the serial number of the device it is intended to be used in. Feature
keys can be used in other RUGGEDCOM ROX II devices, but a low-level alarm will be generated
indicating a hardware mismatch.
Feature keys include the following features:
Feature
VLANs (802.1Q)
QoS (802.1p)
a
MSTP (802.1Q-2005)
RSTP
eRSTP™
SNTP
L2TPv2 and L2TPv3
Port Rate Limiting
Broadcast Storm Filtering
Port Mirroring
SNMP v1/v2/v3
RMON
CLI
HTML User Interface
MPLS
DHCP
Feature Keys
Layer 2 Standard Layer 3 Standard
Edition (L2STD) Edition (L3STD)
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
û
û
Feature Key
Layer 3 Security
Edition (L3SEC)
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
Chapter 1
Introduction
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
5