Adding An Ipv4 Static Route - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
show running-config routing protocol
Where:
• protocol is either IPv4 or IPv6
If routes have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ipv4 | tab
NETWORK DISTANCE
-------------------------------------------------------------------------------------
0.0.0.0/0 -
10.200.16.0/20 -
If no static routes have been configured, add routes as needed. For more information, refer to

"Adding an IPv4 Static Route"

Section 5.23.2
Adding an IPv4 Static Route
To add an IPv4 static route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the IPv4 static route by typing:
routing ipv4 route subnet
Where:
• subnet is the subnet (network/prefix) of the static route
3. If the device has a Layer 3 switch installed, configure the following parameter(s) as required:
NOTE
Only TCP and UDP traffic flows will be accelerated by the IP/Layer 3 switch fabric. Non-IP packet
types, such as ICMP and IGMP, will not be accelerated.
Parameter
hw-accelerate
4. If necessary, configure a black hole connection for the static route. For more information, refer to
Section 5.23.5, "Configuring a Black Hole Connection for an IPv4 Static
5. If necessary, add gateways for the static route. For more information, refer to
Gateway for an IPv4 Static
6. If necessary, add interfaces for the static route. For more information, refer to
Interface for an IPv4 Static
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
7.
404
HW
ACCELERATE GW
-
172.30.128.1
-
or Section 5.23.3, "Adding an IPv6 Static
Route".
Route".
DISTANCE INTERFACE
-
switch.0001
Route".
Description
Synopsis: typeless
If the static unicast route can be hardware accelerated,
this option will be available. For a static unicast route to be
accelerated, the ingress and egress interfaces must be switched.
Route".
RUGGEDCOM ROX II
CLI User Guide
DISTANCE
-
Section 5.23.2,
Section 5.23.6.3, "Adding a
Section 5.23.7.3, "Adding an
Adding an IPv4 Static Route