Image Adjustment; Zoom/Focus Adjustment - Sony LKRA-009 Installation Manual

5-8. Image Adjustment

The zoom/focus adjustment, position adjustment, brightness adjustment, and registration and calling of
adjustment/setting data (FUNCTION MEMORY function) are described here.
Before performing the image adjustment
Perform any of the following operations to call the function memory.
(For the calling procedure, refer to Section 5-8-9.)
. Call the free function memory. (Create a new adjustment data.)
. Call the function memory in which the lens adjustment data is stored. (Create a new adjustment data
using the existing data in function memory.)
. In the case that the function memory is full, call the function memory that can be deleted and tap [Clear].
In any case, register (store) the setting data in the function memory after the adjustment.
(For the registration procedure, refer to Section 5-8-8.)
n
. Register the function in both main projector and sub-projector.
. Use the same function number and name in the main projector and sub-projector.

5-8-1. Zoom/Focus Adjustment

1. Tap the "Configuration" tab.
2. Tap [Projector|$2D%] → [Set|Function].
The Set Function screen is displayed.
[Projector|$2D%]
Screen example
[Set|Function]
3. Select the test pattern to be projected in the Test Pattern pane. (Cross Hatch)
4. Adjust the image size with the Zoom [_]/[+] in the Lens Control pane.
. [_]: Image is reduced.
. [+]: Image is enlarged.
5. Adjust the focus with the Focus [_]/[+] in the Lens Control pane.
. [_]: Image is focused on near point.
. [+]: Image is focused on far point.
Digital Cinema Dual System
Test Pattern pane
Lens Control pane
5-23 (E)