Installation Of 3D Filter And Holder (Lkra-011); Component Parts - Sony LKRA-009 Installation Manual

2-8. Installation of 3D Filter and Holder (LKRA-011)

n
Before installing the 3D filter and holder (LKRA-011), check that the lens adjustment (screen adjustment)
of the two projectors is completed.
Attach the 3D filter and holder (LKRA-011) to the main projector and sub-projector.
They can be attach to the main projector and sub-projector in the same procedure. Here, the example of
procedure when attaching to the main projector is described.
In the standard installation, the 3D filter can be opened/closed in the left direction. When you want to
open/close the 3D filter in the right direction depending on the installation environment, attach the 3D
filter and holder with the lock pin located on the underside.
Standard installation

2-8-1. Component Parts

The 3D filter and holder consist of the following parts.
. Hexagonal spacer:
. Spring washer:
. Washer:
. PSW cross recessed hexagon head bolt: 8 pcs
. 3D filter:
. 3D filter bracket assembly:
. PSW4 x 8:
Required tools
. Long screwdriver (Phillips-head)
. Socket wrench (subtense: 13 mm)
Tightening torque
Tighten the following screws with the tightening torque described below.
. Hexagonal spacer (M8, subtense: 13 mm): 12.5 ?1.0 N.m
. M8 x 25 (subtense: 13 mm):
. PSW4 x 8:
. PSW4 x 10:
. PSW5 x 12:
When using the torque driver with the notation of cN.m, interpret it as follows.
Example: 0.8 N.m = 80 cN.m
Digital Cinema Dual System
When opening/closing in the right direction
8 pcs
8 pcs
8 pcs
2 pcs
2 pcs
8 pcs
10.0 ?1.0 N.m
1.40 ?0.20 N.m
1.40 ?0.20 N.m
3.00 ?0.20 N.m
2-23 (E)