Installation; Required Items; Connection - Sony LKRA-009 Installation Manual

7-3. Installation

7-3-1. Required Items

. LTC cable
(If AUDIO OUTPUT BAL port is used for connection with an audio processor, LTC output must be
tapped from AUDIO OUTPUT BAL cable/connector.)
. LTC converter (If needed)
. Ethernet cable (If needed)

7-3-2. Connection

Since configurations of existing 4D system are different from each other, each system must be properly
configured. Some 4D system needs both LTC output and network automation cue, some needs only LTC
output and some needs neither of them. For the details, contact your local Sony Sales Office/Service Center.
Example of connection between dual system and 4D system
DATA port does not need to be connected.
DATA port network and CTRL port network
must be other segment.
Sub-projector
When using LTC output:
AUDIO OUTPUT BAL port and 4D system LTC port should be connected by LTC cable. If 4D system
does not accept LTC input directly, use an adequate LTC converter. For the details, contact your local
Sony Sales Office/Service Center.
When performing 4D system control command transmission by network automation cue:
Connect the server and 4D system to the theater network.
7-2 (E)
Theater network
Main projector
No.7 pin
AUDIO
OUTPUT
BAL connector
HUB
: Ethernet cable
: LTC/Audio cable
CTRL DATA
port port
Server
PRJ port
SERVER
port
LTC port
LTC
Audio
Audio
Input connector
Network
port
4D System
Audio
processor
Digital Cinema Dual System