Screen Positioning Procedure - Sony LKRA-009 Installation Manual

5-7. Screen Positioning Procedure

Perform the screen positioning of the main projector and sub-projector in the following order. For details
on the procedure, refer to the following "Adjustment procedure" and Section 5-8.
When newly installing and adjusting the dual system or when moving the projector
1. Run the two projectors for 30 minutes or more.
2. Adjust the main projector.
3. Adjust the sub-projector.
4. Perform the adjustment using "Distortion Adjust". Save the adjustment results in the function memo-
ry.
When performing the periodic correction of the dual system that is already adjusted
5. Perform the adjustment using the calibration camera.
Steps 1 to 4 are not required.
Adjustment procedure
1. Run the two projectors for 30 minutes or more.
(1) Tap [Power|ON] of the main projector from GUI.
(2) Tap [Power|ON] of the sub-projector from GUI.
(3) Run both two projectors for 30 minutes or more.
In the meantime, perform step (4).
(4) Adjust the feet of the two projectors to the same height in advance.
2. Adjust the main projector.
(1) Resetting of the electrical correction of main projector
1) Tap [Reset] on the Adjust Distortion screen. (All correction values are reset.)
2) Tap [Reset] on the Electric Shift screen. (H shift and V shift values are reset.)
5-18 (E)
Digital Cinema Dual System