Activating Water Filter Change Warning; Before Starting To Use The Water/Ice Dispenser - Blomberg KWD2330X Operating Instructions Manual

Installation
3.12. Activating water
filter change warning
(For products connected to the mains water line
and equipped with filter)
Water filter change warning is activated
as follows:
1. Within 60 seconds after switching
on the refrigerator, press and hold the
Display and Vacation buttons for 3
seconds.
2. Then enter 1-4-5-3 as password.
Confirming the entered
password password numbers
4
3
4
3
Enter 1-4-5-3 as follows:
Press FF set button for once.
Press FRZ set button for once.
Press FF set button for 4 times.
Press FRZ set button for once.
Press FF set button for 5 times.
Press FRZ set button for once.
Press FF set button for 3 times.
Press FRZ set button for once.
A
A
Selecting the
2
2
1
1
14 / 34 EN
If the password is entered correctly, buzzer
will sound shortly and Filter Change Warning
indicator will turn on.
Automatic filter usage time calculation is not
enabled ex factory.
It must be enabled in products equipped
with a filter.
The refrigerator will give filter change warning
with 6-month intervals automatically.
If the same procedure is repeated when
the automatic filter usage time calculation is
enabled, then the function will be canceled.
3.13. Before starting to use
the water/ice dispenser
(This feature is optional)
• If the water pressure is below 1 bar
then a separate pump may need to be
used.
• Water system of the refrigerator must
be connected to the cold water line. It
must not be connected to hot water
line.
• No water may be obtained in the initial
start-up of the refrigerator. Because
there is air in the system. To discharge
air from the system, press dispenser
latch for 1-2 minutes until water comes
from the dispenser. Water flow may be
irregular at the beginning. After the air
in the system is discharged, water flow
will return to normal.
• During initial use, you will have to wait
approximately 12 hours for the water
to cool down.
• It will take around 1-2 days for the
system to produce the full amount of
ice.
• Water pressure must be between 1-8
bars for the operation of ice/water
dispenser smoothly. For this, check
that 1 glass of water (100 cc) can be
filled in 10 seconds.
Refrigerator / User Manual