Icematic And Ice Storage Container; Ice-Maker - Blomberg KWD2330X Operating Instructions Manual

Operating the product
5.16. Icematic and ice
storage container
*optional
Using the Icematic'
Fill the Icematic with water and place it
into its seat.
Your ice will be ready approximately in
two hours.
Do not remove the Icematic from its sea-
ting to take ice.
Turn the knobs on the ice reservoirs
clockwise by 90˚ degrees.
Ice cubes in the reservoirs will fall down
into the ice storage container below.
Then, you may take out the ice storage
container and serve the ice cubes.
If you wish, you may keep the ice cubes
in the ice storage container.
Ice storage container
Ice storage container is only intended for
accumulating the ice cubes. Do not free-
ze water in it
Otherwise, it will break.

5.17. Ice-maker

(Optional)
Ice maker is located on the upper section
of the freezer cover.
Hold the handles on the sides of the ice
stock reservoir and move up to remove.
Remove the ice-maker decorative lid by
moving up.
OPERATION
To remove the ice reservoir
Hold the ice stock reservoir from the handles,
then move up and pull the ice stock reservoir.
(Figure 1)
To reinstall the ice reservoir
Hold the ice stock reservoir from the handles,
move up with an angle to fit the sides of the
reservoir to their slot and make sure that the
ice selector pin is mounted properly. (Figure
2)
Push downwards firmly, until there is no
space left between the reservoir and the
door plastic. (Figure 2)
If you have difficulty in refitting the reservoir,
turn the rotary gear 90° and reinstall it as
shown in the figure3.
26 / 34 EN
Refrigerator / User Manual