Installing Water Filter - Blomberg IWD 1004 ET Operating Instructions Manual

Installing Water Filter

(in some models)
Installation Requirements
Two different water sources may be
connected to the refrigerator for water
supply: the mains cold water supply and
water in a jug.
A pump should be used for jug water
usage.
Check that the parts stated below are
supplied with your appliance.
1. Union for connection of the water pipe
to the rear of the appliance
2. 3 pieces of pipe clips (In case required
to secure the water pipe)
C
Note: Since the following parts are
not required in use with a jug, they
may not be found in the product you
purchased.
3. 5 meter long water pipe (1/4 inch in
diameter)
4. Cold mains water valve with mesh filter
(Tap Adapter)
5. Water Filter to be fitted to the bracket
inside the fridge compartment.
2
1
14
EN
4
3