Preparation; Things To Be Done For Energy Saving; Efficient Operation; Recommendations On The Fridge Compartment - Blomberg KWD2330X Operating Instructions Manual

4

Preparation

4.1. Things to be done
for energy saving
A
Connecting the product to electric
energy saving systems is risky
as it may restrict operation of the
product.
• Do not leave the doors of your
refrigerator open for a long time.
• Do not put hot food or drinks in your
refrigerator.
• Do not overload the refrigerator.
Cooling capacity will fall when the air
circulation inside is hindered.
• Do not place the refrigerator in places
subject to direct sunlight. Install the
product at least 30 cm away from
heat sources such as hobs, ovens,
heater cores.
• Store your food in refrigerator in
closed containers.
• Thawing frozen food in fridge
compartment will both provide energy
saving and preserve the food quality.
C
The ambient temperature of
the room where you install the
refrigerator should at least be 5°C.
Operating your refrigerator under
cooler conditions than this is not
recommended.
C
Inside of your refrigerator must be
cleaned.
C
If two coolers are to be installed
side by side, there should be at
least 4 cm distance between
them.

4.2. Efficient operation

Specified energy consumption value of your
refrigerator is determined under maximum
load by removing the freezer compartment
upper rack and while other racks and
two bottom drawers are in place. there is
no harm to remove a shelf or drawer to
accommodate the shapes and size of food
to be frozen.
4.3. Recommendations on
the fridge compartment
• Do not allow the food to touch
the temperature sensor in fridge
compartment. To allow the fridge
compartment to keep its ideal
storage temperature, sensor must
not be hindered by food.
• Do not put hot food and beverages
inside the product.

4.4. Initial use

Before starting to use the product,
check that all preparations are made
in accordance with the instructions
in sections "Important instructions
for safety and environment" and
"Installation".
• Clean the interior of the refrigerator
as recommended in the
"Maintenance and cleaning" section.
Check that inside of it is dry before
operating it.
• Plug the refrigerator into the
grounded wall outlet. When the door
is opened the interior illumination will
turn on.
16 / 34 EN
Refrigerator / User Manual