Toshiba TOSVERT VF-S9 Instruction Manual page 59

4.1.5
For reasons of safety, the following parameters have been set up so that they cannot be reprogrammed while
the inverter is running.
Basic parameters
4
Extended parameters
4.1.6
Setting the standard default setting parameter
default settings. (Except for
When
See 4.1.4.
Note: For more details on the standard default setting parameter
Notes on operation
• We recommend that before this operation you write down on paper the values of those parameters,
Parameters that cannot be changed while running
(Automatic acceleration/deceleration)
(Automatic torque boost)
(Automatic environment setting)
(Automatic function setting)
(Command mode selection)
(Frequency setting mode selection)
(Maximum frequency)
(Default setting)
(V/F control mode selection)
(Electronic thermal protection characteristics selection)
Supply voltage correction
Auto-tuning
Rated capacity ratio of motor to inverter
Returning all parameters to standard default setting
)
is set to , the set up parameter is displayed. Setting the setup parameter enable to operate,
because when setting
factory default setting.
Set , and
be changed while the inverter is running.
to 3, all parameters can be returned to the those factory
to 3, all parameters with changed values will be returned to standard
D-8
E6580757
and can
, see 5.7.