Toshiba TOSVERT VF-S9 Instruction Manual page 54

4.1.1 How to set the basic parameters
All of the basic parameters can be set by the same step procedures.
[Steps in key entry for basic parameters]
Switches to the setting monitor mode.
Selects parameter to be changed.
Reads the programmed parameter
setting.
Changes the parameter setting.
Saves the changed value of the
parameter setting.
Steps in setting are as follows (the example shown is one of changing the maximum frequency from 80Hz to
60Hz).
Key operated LED display
→Displays the same
After this,
Displays the operation frequency (operation stopped). (When stan-
dard monitor display selection
quency]).
Press the MON key to display the first basic parameter
(automatic acceleration/deceleration).
Press either the
Pressing the ENTER key reads the maximum frequency.
Press the key to change the maximum frequency to 60Hz.
Press the ENTER key to save the changed maximum frequency.
and frequency are displayed alternately.
→Switches to the
programmed pa-
rameter.
D-3
* The inverters are
shipped from the
factory with set
parameters by default.
* Select the parameter to
be changed from "Table
of parameters".
* If there is something
that you do not
understand during the
operation, press the
MON key to return to
the
Operation
is set to 0 [operation fre-
key or the key to select "
display in the
status monitor
mode.
E6580757
Basic parameters
4
indication.
".
→Displays names
of other parame-
ters.