Monitoring The Operation Status; Status Monitor Mode - Toshiba TOSVERT VF-S9 Instruction Manual

8. Monitoring the operation status

8.1

Status monitor mode

In this mode, you can monitor the operation status of the inverter.
To display the operation status during normal operation:
Press the
Setting procedure (eg. operation at 60Hz)
Item displayed
Note 1
Parameter setting
mode
Operation
frequency
Direction of
rotation
Operation fre-
quency command
Note 2
Load current
Note 3 Input (DC) voltage
Output voltage
Input terminal
Output terminal
(Continued overleaf)
key twice.
Key LED
Communi-
cation No.
operated display
FE00
FE01
FE02
FE03
FE04
FE05
FE06
FE07
H-1
Description
The operation frequency is displayed (during op-
eration). (When the standard monitor display se-
lection parameter
is set at 0 [operation frequency])
The first basic parameter "Automatic accelera-
tion/deceleration ( )" is displayed.
The operation frequency is displayed (during op-
eration).
The direction of rotation is displayed.
( : forward run, : reverse run)
The operation frequency command value is dis-
played.
The inverter output current (load current) is dis-
played. (Default setting : unit %)
The inverter input (DC) voltage is displayed.
(Default setting: unit %)
The inverter output voltage is displayed. (Default
setting: unit %)
The ON/OFF status of each of the control signal
input terminals (F, R, RST, S1, S2 and S3) is dis-
played in bits.
ON:
OFF:
Input terminal (F)
Input terminal
(S3)
Input terminal (R)
Input terminal
Input terminal (RST)
(S2)
Input terminal (S1)
The ON/OFF status of each of the control signal
output terminals (RY, OUT and FL) is displayed in
bits.
ON:
OFF:
Output terminal (RY)
Output terminal (FL)
Output terminal (OUT)
E6580757
8