Toshiba TOSVERT VF-S9 Instruction Manual page 135

[Parameter setting]
Title Function
Prohibition of change of
parameter settings
Resetting method
Only the parameter is designed so that its setting can be modified even if " " (prohibited) is se-
lected.
6.16.2 Changing the display unit to A/V/min
: Unit selection
: Free unit selection
• Function
These parameters are used to change the unit of monitor display.
% ⇔ A (ampere)/V (volt)
Frequency ⇔ Motor speed or load speed
Parameter setting
Title Function
Unit selection
Free unit selection
An example of setting for changing voltage/current percentage display to V/A unit
display
Set to either " " or "
During the operation of the VFS9-2037PM (rated current: 17.5A) at the rated load (100% load), units are dis-
played as follows:
Adjustment range
0: Permitted
( , cannot be modified during
operation)
1: Prohibited
2: Permitted
( ,
eration)
Adjustment range
0: No change
1: % → A (ampere)/V (volt)
2: Free unit selection enabled (
3: % → A (ampere)/V (volt)
Free unit selection enabled (
0.01 ∼ 200.0
".
F-51
can be modified during op-
-1
Default setting
) 0
)
1.00
E6580757
Default setting
0
6