Installing The Stabilizers; Installing The Stabilizer Actuators And Hoses; Stabilizer; Pin (1-1/2 X 8 Inch) - Toro RT600 Operator's Manual

7

Installing the Stabilizers

Parts needed for this procedure:
2

Stabilizer

2

Pin (1-1/2 x 8 inch)

4

Snap ring (1-1/4 inch)

Procedure
1. Lubricate the inside diameter of the 1-1/4-inch and
1-1/2-inch bushings of the stabilizers with grease at the
front and back plates of the backhoe
Figure 18
2. Lubricate the inside diameter of the 1-1/4-inch and
1-1/2-inch pivot point with grease at the front and
back side plates of the stabilizers
3. Lubricate the inside diameter of the 1-1/4-inch holes
with grease at both ends of the hydraulic actuators
(Figure 18).
4. Align the pivot point at the front and back side plates
of one of the stabilizers to the lower bushings in the
backhoe frame (Figure
(Figure 18).
(Figure 18).
19).
1. Snap ring (1-1/4 inch)
2. Pin (1-1/2 x 8 inch)
5. Insert a pin (1-1/2 x 8 inch) through the holes in the
backhoe frame and the stabilizer
6. Secure the pin with 2 snap rings (1-1/4 inch) as shown
in Figure 19.
7. Repeat steps 4 through
to the other side of the backhoe frame.
16
Figure 19
3. Lower bushings
4. Stabilizer
(Figure 19).
6 to install the other stabilizer