Preparing To Install The Attachment Onto The Traction Unit; Installing The Backhoe Wiring Harness; Qty; No Parts Required - Toro RT600 Operator's Manual

Procedure
9
10
11
12
13
14
15
Important: Ensure that there is adequate space to move
the stabilizers and the backhoe arm to full extension
and that the machine and the attachments are clear of
obstructions.
Note: For illustrations of the attachment installed on the
traction unit, refer to (page
1
Preparing to Install the
Attachment onto the Traction
Unit

No Parts Required

Procedure
1. Park the machine on a level surface.
2. Lower the attachment(s) to the ground.
3. Turn off the engine and remove the ignition key.
Description
Clamp
Bolt (3/8 x 1 inch)
Washer (3/8 inch)
Locknut (3/8 inch)
Hose (3/4 x 40-1/2 inch)
90° hydraulic fitting (3/4 inch)
No parts required
E-stop switch
No parts required
No parts required
No parts required
No parts required
).

Qty.

2
1
2
Install the hydraulic-pressure and
hydraulic-return hoses.
1
2
2
Route and connect the backhoe wiring
–
harness.
1 Install the E-stop switch.
–
Install the controls cover and the panels.
–
Bleed the hydraulic system.
Test the operator-presence switch and
–
the E-stop switch.
–
Lubricate the stabilizers.
2
Installing the Backhoe Wiring
Harness
Parts needed for this procedure:
1

Backhoe wiring harness

2

Cable tie

Connecting the Backhoe Wiring
Harness to the Machine
1. Remove the left- and right-side panels and the nose
panel; refer to the traction unit Operator's Manual.
2. Rotate the battery disconnect to the Off position; refer
to the traction unit Operator's Manual.
3. On the backhoe wiring-harness, locate the branch of
the harness that has a 1-pin connector, a 1-socket
connector, and a 2-pin connector
9
Use
(Figure 4).