Dipper And Bucket Controls; Swing-Lock Pedal And Boom-Lock Handle - Toro RT600 Operator's Manual

Figure 44
1. Boom extension and swing
control lever
2. Left stabilizer control lever
3. Right stabilizer control
lever
Boom Swing Control Lever
•
Move the lever to the left to swing the boom to the left
(Figure 44).
•
Move the lever to the right to swing the boom to the right
(Figure 44).
Stabilizer Controls
•
Move the left-stabilizer lever forward to lower the left
stabilizer (Figure 44).
•
Move the left-stabilizer lever rearward to raise the left
stabilizer (Figure 44).
•
Move the right-stabilizer lever forward to lower the right
stabilizer (Figure 44).
•
Move the right-stabilizer lever rearward to raise the right
stabilizer (Figure 44).

Dipper and Bucket Controls

Dipper Extension Control Lever
•
Move the lever forward to move the dipper out
44).
•
Move the lever rearward to move the dipper in
44).
Bucket Control Lever
•
Move the lever to the left to curl (load) the bucket
44).
•
Move the lever to the right to dump (unload) the bucket
(Figure 44).
4. Dipper extension and
bucket control lever
5. E-stop switch
(Figure
(Figure
(Figure
E-Stop Switch
Use the remote engine shutoff control knob to stop the
engine when you are in the backhoe operator's seat.
•
Push down on the control knob to stop the engine
(Figure 44).
•
Pull up on the control knob before re-starting the engine
(Figure 44).
Note: The engine will not start if the control knob is not
pulled up in the Reset position.
Swing-Lock Pedal and Boom-Lock
Handle
Swing-Lock Pedal
Use the swing-lock pedal to lock the boom, the dipper, and
the bucket to the transport (straight forward) position
45). Use the swing-lock pedal to unlock the swing lock after
transporting the machine or before operating the backhoe.
•
To lock the swing lock, move the pedal down, rearward,
and then up.
•
To unlock the swing lock, move the pedal down, forward,
and then up.
1. Swing-lock pedal (locked
position)
28
Figure 45
2. Swing-lock pedal
(unlocked position)
(Figure