Pre-Maintenance Procedures; Lift The Thigh Pad For Rear Access; Removing The Rear Guard; Installing The Rear Guard - Toro Grandstand HDM 74532 Operator's Manual

Table of Contents

Advertisement

Maintenance Service
Interval
Every 100 hours
Every 160 hours
Every 200 hours
Every 500 hours
Yearly
Important:
Refer to your engine owner's manual for additional maintenance procedures.

Pre-Maintenance Procedures

Lift the Thigh Pad for Rear
Access
The pad can be locked open to allow access to the
hydro oil, pumps, ground drive belt, rotating screen,
oil dipstick, and the fuel shut-off valves.
1.
Lower the platform.
2.
Lift the thigh pad all the way up. The pad will
lock in an upwards position.
Figure 17
1. Thigh pad
2. Wireform
3.
Perform any maintenance or adjustment on the
machine.
4.
Lift up on the wireform on the right side under
the pad and lower the pad.

Removing the Rear Guard

1.
Raise and lock the thigh pad.
2.
Grab the top of the rear guard and pull rearward.
Maintenance Procedure
• Service the paper element. (May need more often under severe conditions. See
the Engine Owner's manual for additional information.)
• Change the engine oil. (May need more often under severe conditions.)
• Check the spark plugs.
• Replace the paper element.
• Check the wheel hub torque specification.
• Check the wheel lug nuts.
• Change the hydraulic filter and fluid (Every 250 hours/Yearly if using Mobil 1 15W50)
• Grease the deck belt idler pivot.
g271810
3. Released position
4. Locked position
3.
The top of the rear guard will pop loose from the
brake shaft. Lift the guard from the slots in the
frame and remove.
1. Rear guard

Installing the Rear Guard

To reinstall the rear guard, insert the three tabs into
the slots in the bottom of the frame
the guard forward and snap over the brake shaft.
25
Figure 18
2. Slot
(Figure
18). Push
g271490

Advertisement

Table of Contents
loading

This manual is also suitable for:

Grandstand hdm 74535

Table of Contents