Toro RT600 Operator's Manual page 10

Figure 4
1. Forked terminal (E-stop
switch)
2. Two-socket connector
(operator-presence
switch)
3. Backhoe-wiring harness
4. Go to the left side of the engine compartment, locate
the branch of the machine wiring harness (next to
the starter) that has the 1-socket connector and the
1-pin connector (connected together), and the 2-socket
connector (Figure 5).
Figure 5
1. Two-socket connector
(operator-presence
switch)
2. Socket connector (E-stop)
5. Separate the 1-socket connector and the 1-pin
connector (Figure 4).
6. Connect the 1-pin connector of the backhoe wiring
harness to the 1-socket connector of the machine
wiring harness (Figure
4. Two-pin connector
(machine harness
connection)
5. One-socket connector
(machine harness
connection)
6. One-pin connector
(machine harness
connection)
3. Pin connector (E-stop)
4. Starter
6).
1. Backhoe-wiring harness
2. Two-pin connector
(backhoe harness, E-stop)
3. Two-socket connector
(machine harness, E-stop)
4. One-pin connector
(machine harness, E-stop)
7. Connect the 1-socket connector of the backhoe wiring
harness to the 1-pin connector of the machine wiring
harness (Figure
8. Connect the 2-socket connector of the backhoe wiring
harness to the 2-pin connector of the machine wiring
harness (Figure
Routing the Backhoe Wiring Harness
on the Machine
1. Route the backhoe wiring harness forward, along the
frame rail and below the top flange of the rail.
2. Route the wiring harness over the forward axle and
through the left hole in the bulkhead plate
Note: Route the harness inboard of the left tilt
cylinder for the backfill blade.
10
Figure 6
5. One-socket connector
(machine harness, E-stop)
6. One-socket connector
(backhoe harness, E-stop)
7. One-pin connector
(backhoe harness, E-stop)
6).
6).
(Figure 7).