Installing The E-Stop Switch - Toro RT600 Operator's Manual

6. Route the branch of the wiring harness with the
2-forked electrical terminals forward of the hydraulic
manifold and hoses, and then route it to the right
(Figure 28).
Figure 29
1. E-stop switch
2. Hydraulic manifold
7. Connect the 2-forked electrical terminals to terminals
A and B with the terminal screws and the saddle
washers of the E-stop switch, and tighten the screws
(Figure 30).
3. Forked terminals
4. Backhoe-wiring harness
1 2
1. Terminal screw A
2. E-stop switch
11

Installing the E-Stop Switch

Parts needed for this procedure:
1 E-stop switch
Procedure
1. Disassemble the E-stop switch as follows:
A. Remove the button cover from the E-stop button
().
1
2
1. Button cover
2. Screw
3. E-stop button
21
3 4
G023512
Figure 30
Bottom view
3. Saddle washers
4. Terminal screw B
3
4
5
6
Figure 31
4. Jam nut
5. C-clip
6. E-stop switch
G023522