Toro RT600 Operator's Manual page 18

Note: Allow the pin to extend slightly through
the pivot point.
B. Slip a 3 washers (1-3/8 inch) over the short
segment of the pin
C. Remove the plugs from the ports of the cylinder
and cover the holes with a clean rag
D. Extend the piston fitting of the cylinder to the 32
mm (1-1/4 inch) pivot point of the stabilizer.
Note: Residual hydraulic fluid may eject from
the cylinder ports.
E. Continue inserting the pin through the piston
fitting of the cylinder
F. Align 3 washers (1-3/8 inch) between the piston
fitting of the cylinder and the other pivot point of
the stabilizer (Figure
G. Continue inserting the pin through the washers
and the pivot point of the stabilizer
3. Secure the 2 pin (1-1/4 x 8 inch) with 4 snap rings
(1-1/8 inch) as shown in
4. Repeat steps 1 through
the other stabilizer.
Attaching the Hoses to the Hydraulic
Actuators
1. Install the 2 hydraulic fittings (3/8 inch, 90°) into the
hydraulic ports of the actuator
Note: Ensure that the fittings point toward each other
(Figure 21).
1. 90° hydraulic fittings
2. Remove the hoses from inside the pockets for the
stabilizer mounting point
(Figure 20).
(Figure
(Figure 20).
20).
(Figure
Figure 20.
3 for the hydraulic cylinder for
(Figure 21).
Figure 21
(Figure 22).
20).
1. Extend hose
2. Cable ties
20).
3. Route the extend and retract hoses to the fittings that
you installed in step 1.
4. Connect the extend hose to the fitting in the extend
port, and connect the retract hose to the fitting in the
retract port
1. Extend hose
5. Secure the hydraulic hoses to the cylinder of the
actuator with cable ties as shown in
Figure 23.
6. Repeat steps
backhoe.
18
Figure 22
3. Retract hose
(Figure 23).
Figure 23
2. Retract hose
Figure 22
1 through 5 for the other side of the
and