Bolt (3/4 X 4 Inches); Nut (3/4 Inch) - Toro Groundsmaster 3200 Series Operator's Manual

1
Preparing the Machine and
Cab
Parts needed for this procedure:
2

Bolt (3/4 x 4 inches)

2

Nut (3/4 inch)

Procedure
Note:
Save the shipping pallet for long term storage
after the cab is removed. Save all hardware for the
machine when installing or removing the cab.
1. Park the machine on a level surface, engage the
parking brake, lower the attachment, shut off the
engine, and remove the key.
2. Disconnect the negative (-) battery cable from
the battery.
3. Remove the nut, bolt, and spacer securing the
cable to the traction pedal and rotate the pedal
towards the seat
1. Foot pedal
2. Locknut
4. Remove the ROPS pins and place them into
down position hole
(Figure 1).
Figure 1
3. Bolt
4. Spacer
(Figure 2).
1. Cotter pin
5. Install the bolt (3/4 x 4 inches) into the top hole
of the roll bar and secure it finger tight with a nut
(3/4 inch). Refer to
Note:
Ensure that the bolt is installed on the
inside of the roll bar.
1. Install the bolt (3/4 x 4
inches) on the inside.
g301596
6. Remove the front mower-deck latch from the
front of the machine
and hardware.
5
Figure 2
2. Pin
(Figure 3).
Figure 3
2. Nut (3/4 inch)
(Figure 4). Save the latch
g302033
g302032