Weight (6 Kg Or 15 Lb); Bolt (3/8 X 3-1/2 Inches); Washer (3/8 Inch); Locknut (3/8 Inch) - Toro Groundsmaster 3200 Series Operator's Manual

Figure 29
1. Cable tie
2. Relay (70 A)
3. Connect to the main
machine harness
2. Remove the nut that secures the positive-battery
clamp to the positive-battery terminal.
3. Attach the positive-battery terminal from the wire
harness to the bolt used to secure the battery
clamp.
4. Secure the clamp with the nut you removed
previously.
5. Repeat the previous steps for the negative
battery terminal on the wire harness.
6. Install the connector to the fluid tank
7. Plug the connector shown in
main harness of the machine.
8. Install a fuse (10 A) to the traction-unit fuse
block; refer to the electrical-system maintenance
section of your traction unit Operator's Manual
for the appropriate location.
g302187
4. Fluid tank connector
5. Battery terminals
6. Unused connector
(Figure 29).
Figure 29 to the
11
Installing the Weights
Parts needed for this procedure:
2

Weight (6 kg or 15 lb)

2

Bolt (3/8 x 3-1/2 inches)

2

Washer (3/8 inch)

2

Locknut (3/8 inch)

Procedure
1. Install 2 weights (6 kg or 15 lb) between the
frame and the rear bumper with 2 bolts (3/8
x 3-1/2 inches), 2 washers (3/8 inch), and 2
locknuts (3/8 inch). Refer to
2. If you also install an attachment (e.g., a snow
blade, snow broom, or cutting unit), refer to
the traction unit Operator's Manual for the
appropriate amount of rear weight.
1. Bolt (3/8 x 3-1/2 inches)
2. Rear bumper
3. 6 kg (15 lb) weights
4. Washer (3/8 inch)
20
Figure 30.
Figure 30
5. Locknut (3/8 inch)
6. Frame
7. 19 kg (42 lb) weights
g315463