Figure 13
1. Foam seal
6.
Align the cab over the roll bar.
7.
While lowering the cab, position the vent tubes
through the rear posts
Note:
Ensure that the traction pedal is rotated
rearward towards the seat.
8.
Lower the cab until it is approximately 51 mm (2
inches) above the firewall and machine.
9.
Install the roll bar seals around each side of the
roll bar
(Figure
14).
g301543
2. Foam seal installed
(Figure
16).
10.
Install the left cover and 1 retainer cover into the
left seal and secure the covers with 4 screws
(1/4 x 3/4 inches); refer to
11.
Install the right cover and 1 retainer cover into
the right seal and secure the covers with 4
screws (1/4 x 3/4 inches); refer to
1. Retainer cover
2. Roll bar seal
3. Screws (1/4 x 3/4 inches)
12.
Lower the cab onto the firewall and machine.
13.
Loosely install the mower deck latch to the front
of the cab
(Figure
14.
Loosely install the ROPS mounts to secure the
cab to the roll bar on the machine
15.
Loosely install the left ROPS stop on the corner
of the roll bar with 2 bolts (3/8 x 1 inch), a ROPS
brace, and 2 nuts (3/8 inch).
16.
Loosely install the right ROPS stop on the corner
of the roll bar with 2 bolts(3/8 x 1 inch), a ROPS
brace, and 2 nuts (3/8 inch).
10
Figure
14.
Figure
Figure 14
4. Right cover
5. Left cover
6. Covers installed
4).
(Figure
14.
g301688
15).