Nut (5/16 Inch); Plate Clamp; Tube Clamp - Toro Groundsmaster 3200 Series Operator's Manual

Figure 15
1. Bolt (3/8 x 1 inch)
2. ROPS stop
3. ROPS mount
Note:
Ensure that the ROPS bolts are tightened
last (Figure 3).
17. After all the parts and hardware is installed,
tighten the hardware.
18. Torque all nuts and bolts attaching the cab to
the roll bar to 127 to 157 N∙m (94 to 116 ft-lb).
Refer to Figure 15
19. Torque the nuts and bolts for the mower deck
latch in the front of the cab to 127 to 157 N∙m
(94 to 116 ft-lb). Refer to
20. Torque the roll bar bolt and nut to 329 to 403
N∙m (243 to 297 ft-lb). Refer to
21. Install the cab roof
22. Install the nut, bolt, and spacer to secure the
cable to the traction pedal
4. ROPS brace
5. Nuts (3/8 inch)
6. Hardware installed
Figure 4.
Figure 3.
(Figure 11).
(Figure 1).
4
Installing the Vent Tubes
Parts needed for this procedure:
2 Bolt (5/16 x 1-1/2 inch)
2

Nut (5/16 inch)

2

Plate clamp

2

Tube clamp

Procedure
1. Install the vent tubes to each side of the cab.
Refer to Figure
2. Secure each vent tube with a bolt (5/16 x 1-1/2
inch), a plate clamp, a tube clamp, and a nut
(5/16 inch)
g301843
1. Nut (5/16 inch)
2. Left side of the machine
(from operator's position)
3. Bolt (5/16 x 1-1/2 inch),
4. Plate clamp
3. Install the side panels previously removed
(Figure 11).
11
16.
(Figure 16).
Figure 16
5. Tube clamp
6. Vent tube
7. Vent tube installed in the
lower left of the cab
g330010