Toro Groundsmaster 3200 Series Operator's Manual page 16

7
Installing the Hoses for the
37 hp Engine
Parts needed for this procedure:
1 Hose
1 Female coupler
1 Female dust plug
2 Straight fitting (3/8 NPT x 5/8 barb)
4 Hose clamp
1 Male coupler
1 Male dust plug
2 R-clamp
2 Carriage bolt (1/4 x 3/4 inch)
2 Flange nut (1/4 inch)
2 Engine fitting
8 Cable ties
1 Straight adaptor (3/8 inch)
1
Adaptor (M16)
Procedure
1. Apply sealant to the straight fittings (3/8 NPT x
5/8 barb), skipping the first thread.
2. Slip hose clamps over the hoses.
3. Slip the dust plug and dust cap over the barbed
end of the assemblies
4. Thread the straight fittings (3/8 NPT x 5/8 barb)
into the male and female couplers
5. Tighten the straight fittings (3/8 NPT x 5/8 barb)
in the male and female couplers 2 to 3 turns
from finger-tight.
6. Insert the barbed end of the assemblies into the
hoses and secure them with the hose clamps
(Figure 24).
7. Remove the existing bracket from the machine
frame and radiator
hardware.
(Figure 24).
(Figure
(Figure 23). Save the
1. Nut
2. Bolt
3. Right side
8. Drain half of the engine coolant from the radiator
by using the valve on the right side of the
radiator as shown in
9. Locate and remove the engine plugs shown in
Figure 24.
24).
16
Figure 23
4. Existing bracket
5. Radiator valve
Figure 23.
g315428