Washer-Fluid Bracket; Washer-Fluid Tank; Carriage Bolt (5/16 X 3/4 Inch); Locknut (5/16 Inch) - Toro Groundsmaster 3200 Series Operator's Manual

Figure 25
1. Direction of fluid flow
2. Couplers installed
3. R-clamp
4. Cable tie
17. Secure the hoses away from moving parts and
hot surfaces with cable ties
18. Fill the radiator with engine coolant.
19. Start the engine and purge the air out of the
cooling system.
20. Shut off the engine and check the engine-coolant
level.
21. If needed, add more engine coolant.
Note:
When the engine is cold, the coolant
level should be no higher than the FULL (COLD)
mark (bottom mark).
Note:
Refer the traction unit Operator's Manual
for the correct fluid.
g301829
5. Nut (1/4 inch)
6. Carriage bolt (1/4 x 3/4
inch)
7. Tag—noting hot line
(Figure 25).
8
Installing the Washer-Fluid
Tank
Parts needed for this procedure:
1

Washer-fluid bracket

1

Washer-fluid tank

4

Carriage bolt (5/16 x 3/4 inch)

4

Locknut (5/16 inch)

Procedure
1. Install the tank to the bracket with 4 carriage
bolts (5/16 x 3/4 inch) and 4 nuts (5/16 inch);
refer to Figure
1. Washer-fluid tank
2. Locknut (5/16 inch)
3. Existing hardware
2. Install the tank and bracket to the frame and
radiator with the previously removed hardware
(Figure 21 or Figure
18
26.
Figure 26
4. Carriage bolt (5/16 x 3/4
inch)
5. Washer-fluid bracket
23).
g301514