Toro Groundsmaster 3200 Series Operator's Manual page 23

Storage
Remove the cab from the machine for storage.
Preparing to Remove the
Cab from the Machine
1. Move the machine underneath the cab hoist,
shut off the engine, set the parking brake, and
remove the key.
2. Allow the engine to cool.
3. Remove the bolt and nut securing traction pedal
(Figure 1).
4. Remove the front mower-deck latch from the
front of the machine
5. Remove the bolts from the right armrest and
rotate it to the center
6. Remove the left and right panels inside the cab
(Figure 10).
7. Remove the vent tube from each side of the cab
behind the panels
8. Tilt the steering column to its lowest position;
refer to the machine Operators' Manual.
9. Disconnect the black (-) cable from the battery.
(Figure 4).
(Figure 5).
(Figure 16).
Disconnecting the Wire
Harness
1. Disconnect the wire harness secured to the
machine from the wire harness secured to the
cab at the relay location
2. Disconnect the connect attached to the main
machine harness
3. Cover the connectors for the machine and cab
with tape to keep them clean.
Disconnecting the Hoses
1. Disconnect the washer hose
2. Disconnect the heater hoses
Note:
Be prepared to collect or wipe the
fluid that can drain from the hoses when you
disconnect them.
1. Male coupler
3. Seal the heater hoses using the dust caps
(Figure 34).
23
(Figure 29).
(Figure 29).
(Figure 20).
(Figure 34).
Figure 34
2. Female coupler
g302188